1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
|
SUBROUTINE slATMD (TDK, PMB, RH, WL1, A1, B1, WL2, A2, B2)
*+
* - - - - - - -
* A T M D
* - - - - - - -
*
* Apply atmospheric-dispersion adjustments to refraction coefficients.
*
* Given:
* TDK d ambient temperature, K
* PMB d ambient pressure, millibars
* RH d ambient relative humidity, 0-1
* WL1 d reference wavelength, micrometre (0.4D0 recommended)
* A1 d refraction coefficient A for wavelength WL1 (radians)
* B1 d refraction coefficient B for wavelength WL1 (radians)
* WL2 d wavelength for which adjusted A,B required
*
* Returned:
* A2 d refraction coefficient A for wavelength WL2 (radians)
* B2 d refraction coefficient B for wavelength WL2 (radians)
*
* Notes:
*
* 1 To use this routine, first call slRFCO specifying WL1 as the
* wavelength. This yields refraction coefficients A1,B1, correct
* for that wavelength. Subsequently, calls to slATMD specifying
* different wavelengths will produce new, slightly adjusted
* refraction coefficients which apply to the specified wavelength.
*
* 2 Most of the atmospheric dispersion happens between 0.7 micrometre
* and the UV atmospheric cutoff, and the effect increases strongly
* towards the UV end. For this reason a blue reference wavelength
* is recommended, for example 0.4 micrometres.
*
* 3 The accuracy, for this set of conditions:
*
* height above sea level 2000 m
* latitude 29 deg
* pressure 793 mb
* temperature 17 degC
* humidity 50%
* lapse rate 0.0065 degC/m
* reference wavelength 0.4 micrometre
* star elevation 15 deg
*
* is about 2.5 mas RMS between 0.3 and 1.0 micrometres, and stays
* within 4 mas for the whole range longward of 0.3 micrometres
* (compared with a total dispersion from 0.3 to 20.0 micrometres
* of about 11 arcsec). These errors are typical for ordinary
* conditions and the given elevation; in extreme conditions values
* a few times this size may occur, while at higher elevations the
* errors become much smaller.
*
* 4 If either wavelength exceeds 100 micrometres, the radio case
* is assumed and the returned refraction coefficients are the
* same as the given ones. Note that radio refraction coefficients
* cannot be turned into optical values using this routine, nor
* vice versa.
*
* 5 The algorithm consists of calculation of the refractivity of the
* air at the observer for the two wavelengths, using the methods
* of the slRFRO routine, and then scaling of the two refraction
* coefficients according to classical refraction theory. This
* amounts to scaling the A coefficient in proportion to (n-1) and
* the B coefficient almost in the same ratio (see R.M.Green,
* "Spherical Astronomy", Cambridge University Press, 1985).
*
* Last revision 2 December 2005
*
* Copyright P.T.Wallace. All rights reserved.
*
* License:
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation; either version 2 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program (see SLA_CONDITIONS); if not, write to the
* Free Software Foundation, Inc., 51 Franklin Street, Fifth Floor,
* Boston, MA 02110-1301 USA
*
* Copyright (C) 1995 Association of Universities for Research in Astronomy Inc.
*-
IMPLICIT NONE
DOUBLE PRECISION TDK,PMB,RH,WL1,A1,B1,WL2,A2,B2
DOUBLE PRECISION F,TDKOK,PMBOK,RHOK,
: PSAT,PWO,W1,WLOK,WLSQ,W2,DN1,DN2
* Check for radio wavelengths
IF (WL1.GT.100D0.OR.WL2.GT.100D0) THEN
* Radio: no dispersion
A2 = A1
B2 = B1
ELSE
* Optical: keep arguments within safe bounds
TDKOK = MIN(MAX(TDK,100D0),500D0)
PMBOK = MIN(MAX(PMB,0D0),10000D0)
RHOK = MIN(MAX(RH,0D0),1D0)
* Atmosphere parameters at the observer
PSAT = 10D0**(-8.7115D0+0.03477D0*TDKOK)
PWO = RHOK*PSAT
W1 = 11.2684D-6*PWO
* Refractivity at the observer for first wavelength
WLOK = MAX(WL1,0.1D0)
WLSQ = WLOK*WLOK
W2 = 77.5317D-6+(0.43909D-6+0.00367D-6/WLSQ)/WLSQ
DN1 = (W2*PMBOK-W1)/TDKOK
* Refractivity at the observer for second wavelength
WLOK = MAX(WL2,0.1D0)
WLSQ = WLOK*WLOK
W2 = 77.5317D-6+(0.43909D-6+0.00367D-6/WLSQ)/WLSQ
DN2 = (W2*PMBOK-W1)/TDKOK
* Scale the refraction coefficients (see Green 4.31, p93)
IF (DN1.NE.0D0) THEN
F = DN2/DN1
A2 = A1*F
B2 = B1*F
IF (DN1.NE.A1) B2=B2*(1D0+DN1*(DN1-DN2)/(2D0*(DN1-A1)))
ELSE
A2 = A1
B2 = B1
END IF
END IF
END
|
